BeastX NANOBEAST FBL Unit BXM76900
$109.99 $89.99
he NANOBEAST is a control unit for small and smallest RC model helicopters without auxiliary rotor level.
In stock
Description
The NANOBEAST is a control unit for small and smallest RC model helicopters without auxiliary rotor level. The integrated gyroscopic elements stabilize the helicopter as much as possible so that it follows only the control commands of the pilot. The steering feel can be adjusted from tame to extremely agile. Thus, the model meets almost all requirements of pilots, no matter if beginner or 3D professional. Through a paid firmware upgrade, the system can be extended to “ProEdition”.
This offers additional functions such as the AttitudeControl for position stabilization and rescue of the model in unsafe attitude, as well as a bank switching, which allows to switch between different parameter sets in flight.
For basic setting and tuning of the system a computer (Windows / mac), a smartphone or tablet (iOS / Android) with Bluetooth LE is required. Depending on the technology used, you will still need a USB2SYS (for computer) or BLE2SYS (for smartphone / tablet) interface.
This is not included and must be purchased separately! The configuration then takes place via the StudioX software, which is offered for free download.
Supported Receiver
Types / Transmission Protocols • SRXL: JR® XBus (Mode B), Multiplex® SRXL (V1 + V2), Jeti® UDI, Graupner / SJ® HOTT SUMD, Spectrum® SRXL
• Futaba® SBUS
• Single Satellite (Spektrum® DSM2 / DSMX , JR® RJ-01 DMSS)
• Jeti® EXBUS
• ALIGN / FlySky iBus
• PPM sum signal (SPPM)
Technical specifications
Receiver connections: Spektrum® / JR® single satellite, sum signal connector for Graupner® HOTT, Futaba® SBus, Jeti® exBus, FlySky® iBus, FrSky® SRXL,
Multiplex® SRXL, JR® XBus (B), Spectrum® SRXL, Align® iBus, SPPM total signal
Input voltage: 4.8V to 6.0V
Recommended helicopter size: 180’s – 250’s Electroheli
Dimensions: 32x20x10mm
Weight: 5.8g
Content:
- 1 x NANOBEAST control unit
- 1 x patch cable for total signal receiver
- 2 x adhesive pad
- 1 x manual
- 1 x decal sheet
Additional information
Weight | 0.4375 lbs |
---|---|
Dimensions | 6 × 6 × 3 in |
Related products
-
Align Trex T15G Flybarless System (S-FHSS) HEG15011XX
In stock
-
Align 150GRSA Flybarless System Set A.BUS) HEG15006
In stock
-
Align Trex 700N / 700E / 700E F3C Metal Tail Torque Tube Unit HN7053B
In stock
-
Align MiniGRS Flybarless System HEGGRS01
In stock
-
Align Trex 300X Mini A.Bus Receiver (Used with A10 Transmitter Only) HEG00003
Out of stock
-
Align Trex 150 GRS HEG15002
In stock